MicroBoost V1.0
This is the Polymorph MicroBoost. Drives MAC solenoid valves to control your wastegate at 30Hz to reach a target boost pressure using fully tuneable PID control routines. The live graphing feature allows this to also display boost pressure over time, allowing you to see how your boost builds through each pull. Features a full menu allowing you to tune parameters for your build’s MAP sensor, PID control variables, and your target boost pressure. Values that you input are saved and loaded next time you power your vehicle on. Comes with a pre-pinned JST-XH 4 pin male plug, ~1ft of silicone wiring and a pinout to make the install as simple as possible!
Only requires 12V power, ground, MAP sensor output, and solenoid control wire!
Printed instructions are included with a pinout diagram to ease installation while in the car.
This is the Polymorph MicroBoost. Drives MAC solenoid valves to control your wastegate at 30Hz to reach a target boost pressure using fully tuneable PID control routines. The live graphing feature allows this to also display boost pressure over time, allowing you to see how your boost builds through each pull. Features a full menu allowing you to tune parameters for your build’s MAP sensor, PID control variables, and your target boost pressure. Values that you input are saved and loaded next time you power your vehicle on. Comes with a pre-pinned JST-XH 4 pin male plug, ~1ft of silicone wiring and a pinout to make the install as simple as possible!
Only requires 12V power, ground, MAP sensor output, and solenoid control wire!
Printed instructions are included with a pinout diagram to ease installation while in the car.
This is the Polymorph MicroBoost. Drives MAC solenoid valves to control your wastegate at 30Hz to reach a target boost pressure using fully tuneable PID control routines. The live graphing feature allows this to also display boost pressure over time, allowing you to see how your boost builds through each pull. Features a full menu allowing you to tune parameters for your build’s MAP sensor, PID control variables, and your target boost pressure. Values that you input are saved and loaded next time you power your vehicle on. Comes with a pre-pinned JST-XH 4 pin male plug, ~1ft of silicone wiring and a pinout to make the install as simple as possible!
Only requires 12V power, ground, MAP sensor output, and solenoid control wire!
Printed instructions are included with a pinout diagram to ease installation while in the car.